6-2-26 Section 6: Installation
ST290 Instrument System Owner’s Handbook
2. Prepare the cable for connection to the instrument as described under
Cable preparation on page 6-2-5.
3. Connect the crimps to the appropriate connector pins.
Figure 2-29: SeaTALK
2
instrument connections
4. Slide the boot fully home into the instrument connector (see Figure
2-30 ).
Figure 2-30: Sliding cable boot into position
White (CAN_HI)
Blue (CAN_LO)
Gray (Screen)
Black (-ve)
Red (+12 V)
D5795-1
Connections
as above
D6082-1
81183_2 S6.book Page 26 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
