Raymarine St290 - Page 232

7-4-4 Section 7: System Setup
ST290 Instrument System Owner’s Handbook
Figure 4-3: Compass instrument calibration second stage
Calibration
entry
screen
Press simultaneously
D5724-1
Hold down
for approximately 12 seconds
Boat
show
mode
Do NOT set to
on (bS1)
to switch User cal
(the first calibration
stage), to either
on (1) or off (0)
Factory
defaults
Press
to set required value
F1 = factory defaults
F0 = current settings
After hold down
of 2 seconds
After hold down
of 12 seconds
Software
version
After hold down
of 4 seconds
Switch User
cal on/off
Press
Pointer
response
to set required
value
P1 (slowest) to
P15 (fastest)
Press
Digital
display
response
to set required
value
d1 (slowest) to
d15 (fastest)
Press
for 2 secondsTo accept settings & exit calibration, hold down
OR
AND
AND
OR
OR
OR
AND
81183_2 S7.book Page 4 Wednesday, May 7, 2003 1:52 PM