Model 8210/8250 Maintenance Manual Section 6. Messages and Codes
Messages and Caution Codes
Publication:1146945/001, Revised: 25 Sep 2018 6-5
Section 6. Messages and Codes
Messages and Caution Codes
NOTE: Codes C001 through C012 are iBATTERY related error codes. Refer to iBATTERY Battery
Monitoring System Installation and Maintenance Instructions.
Code ‘GATE’
Code ‘TEST’
Code ‘SLO’
Code Title Battery Gate Switch Open
Operator Display 'GATE'
System Response Travel limited to 1 MPH (1.6 km/h)
Reason Battery gate missing and operator moved handle out-of-neutral. The TA detected
that Battery Gate Interlock switch S21 or S22 is open.
Tests to Run Troubleshoot wiring to and from switches. See “Pinout Matrix” on page 8-9.
How to Clear Make sure the battery gate is installed correctly. Adjust or replace switches.
Code Title TEST
Operator Display 'TEST'
System Response Truck functions are not allowed.
Alarm Sounds No
Reason New VM was installed that was not loaded with software.
Tests to Run None
How to Clear Code is cleared after the software is loaded in the VM.
Code Title Creep Speed
Operator Display 'SLO'
NOTE: This can be mistaken for a code 075 if the display is read upside-down.
There is no code 075.
System Response Travel Limited to Creep Speed
Reason Click-to-Creep feature activated.
Tests to Run None
How to Clear With the handle in brake position, quickly click the speed control twice to
deactivate creep speed.
Property of American Airlines
To Next Page
Loading...