PAPER FEED
A265/A267 2-64 SM
2.8.9 SPECIAL PAPER SETTING
When feeding thick paper and envelopes, the user must use the 2nd paper tray (if
the optional by-pass table is not installed), and turn lever [A] to the right. Then,
when sliding the tray into the machine, the lever will not push the special paper
switch [B] (it stays off), and the machine detects that there is special paper in the
2nd paper tray.
When the machine detects the special paper signal, the fusing temperature and the
transfer roller current will be changed as follows.
1. Fusing temperature: Current operation temperature + 10
°
C
2. Transfer roller current:
A3 width (11”): 14
µ
A
B4 width (10”): 15
µ
A
A4 width (8.5”): 17
µ
A
A5 width (5.5”): 20
µ
A
Note that for the by-pass tray, the fusing and transfer conditions for special paper
are also applied if the user uses thick (non-standard) mode.
A267D703.WMF
[A]
[B]
To Next Page
Loading...
