PICK-UP AND SEPARATION
SM 8-9 A265/A267
ARDF
A858
2.2 PICK-UP AND SEPARATION
The original is set with the image facing up. The original pushes actuator [A] and
the original set sensor [E] is activated.
After pressing the start button, the pick-up solenoid [D] is activated and the lift plate
[C] lifts the original up until it comes in contact with the pick-up roller [B]. The pick-
up roller then feeds the top sheet of paper.
After being fed from the pick-up roller, the topmost sheet is separated from the
stack by the separation roller and sent to the first transport roller.
The mechanism is an FRR system (feed and reverse roller), consisting of the
original feed belt [F] and separation roller [G].
A858D504.WMF
A858D505.WMF
[A]
[B]
[C]
[D]
[E]
[B]
[F]
[G]
To Next Page
Loading...
