DOWNLOADING NEW SOFTWARE
A265/A267 18-12 SM
4.2.2 ERROR MESSAGES DURING THE SOFTWARE DOWNLOAD
If downloading failed, one of the following error messages appears. At this time,
press the “CONFIRM” bottom in the display to re-try the download.
Message Action
SYS Erasing Failed ADDR:XXXXXXXX
SYS Writing Failed ADDR:XXXXXXXX
SYS Verify Failed ADDR:XXXXXXXX
APL Erasing Failed ADDR:XXXXXXXX
APL Writing Failed ADDR:XXXXXXXX
APL Verify Failed ADDR:XXXXXXXX
NIC board is not equipped
NIC Initialization failed. CODE:XXXX
NIC Download mode is disable
NIC Writing Failed ADDR:XXXXXXXX
Re-try the download. If the
download fails again, replace the
scanner controller.
NIC Host Service Error CODE:XXXX Re-try the download. If the
download fails again, replace the
scanner controller.
Check whether the STP cable is
disconnected. If it is connected,
disconnect the cable and re-try the
downloading.
To Next Page
Loading...
