Ricoh Aficio 270 - Output Check (Sp5-804); Output Check Table

SERVICE PROGRAM MODE 20 September 1999
A265/A267 4-66 SM
4.2.5 OUTPUT CHECK (SP5-804)
CAUTION:
To prevent mechanical or electrical damage, do not keep an electrical
component on for a long time.
1. Access SP mode 5-804.
2. Select the SP number that corresponds to the component you wish to check
(see the table below), then press “OK” or the
#
key.
3. Press “1”, then press “OK” or the
#
key to check that component.
4. To interrupt the test, exit the SP mode.
5. If you wish to check another component, re-enter the SP mode.
Output Check Table
NOTE:
Pull out the tray before performing the output checks from 29 to 32.
Number Description
0 Not used
1 Main motor (forward)
2
Main motor (Reverse) Do not use
3 Registration clutch
4 Not used
5 Toner supply motor
6 Not used
7 ~ 8 Not used
9 Exhaust fan (High Speed)
10 Exhaust fan (Low Speed)
11 Not used
12 By-pass feed clutch
13 Upper paper feed clutch
14 Lower paper feed clutch
15 Upper paper lift motor (Up)
16 Upper paper lift motor (Down)
17 Lower paper lift motor (Up)
18 Lower paper lift motor (Down)
Prev. Next OK Back
Output Check
Data: 0
[Serviceman P-Mode]
Code: 0
A250M502.WMF