OPTIONAL UNITS
SM 3-19 A265/A267
Installation
A895
3.2.6 HANDSET
1. At first, make 2 holes in the right side cover at the places marked with dimples
as shown.
2. Attach the bracket [A] enclosed with the fax unit (2 screws).
NOTE:
The bracket and the cable clamp enclosed with the handset are not
used for this machine.
3. Remove the label from the handset cradle [B]. Attach the cradle [B] to the
bracket [A] (2 screws) then replace the label.
4. Install the handset [C] on the cradle [B], then connect the cable to the "TEL1" or
"TEL2" jack at the rear of the machine.
5. Attach the clamps [D] to the cover as shown, then run the cable though the
clamps.
6. Select the dialing method.
H160I551.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
