SERVICE PROGRAM MODE
SM 4-73 A265/A267
Service
Tables
Display during writing
Display when the download is complete
Display if writing failed
NOTE:
To see the current firmware version, check SP 7-801-2.
Program Upload (SP5-826)
1. Turn off the main switch.
2. Plug the flash memory card [A] into the card slot (see previous page).
NOTE:
Make sure that the surface printed “A” faces the rear side of the
machine (as viewed from the front of the machine).
3. Turn on the main switch.
4. Access SP mode 5-826.
5. The machine erases the current software, then writes the new software to the
flash memory card. This takes about 60 seconds. If uploading failed, an error
message appears. At this time, repeat the upload procedure.
6. Turn off the main switch, then remove the IC card.
Program Download
[Serviceman P-Mode]
Prev. Next OK Exit
Status: 1-02254 1.05 NA 04/1 11:02
A265M506.WMF
Program Download
[Serviceman P-Mode]
Prev. Next OK Exit
Completed Sum = 4F2F 1.05 04/1 11:02
A265M504.WMF
Program Download
[Serviceman P-Mode]
Loading error!!! 04/1 11:02
Prev. Next OK Exit
A265M505.WMF
To Next Page
Loading...
