Ricoh Aficio 270 - Dedicated Transmission Parameters; Programming Procedure

DEDICATED TRANSMISSION PARAMETERS
A265/A267 4-78 SM
4.4 DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has eight bytes of programmable
parameters allocated to it. If transmissions to a particular machine often experience
problems, store that terminal’s fax number as a Quick Dial or Speed Dial, and
adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the eight bytes will be
described.
4.4.1 PROGRAMMING PROCEDURE
1. Make sure the machine is in “Facsimile” mode. Press “User Tools” key then
choose “Fax”.
2. Press
!
, then either choose “Registering Quick Dial” or “Registering Speed
Dial”.
Example:
Change the Parameters in Quick Dial 10.
3. Press Quick Dial key 10.
NOTE:
The selected Quick or Speed Dial must be programmed beforehand.
4. When the programmed dial number is displayed, press S - V - C using Quick
Dial keys, then press “Start”.
5. The settings for byte 0 are now displayed. Press a number from 0 to 7
corresponding to the bit that you wish to change.
Example:
Change bit 7 to 1: Press 7
6. To scroll through the parameter bytes, either:
Select the next byte: press “
↓
Switch”
or
Select the previous byte: press “
↑
Switch” until the correct byte is displayed.
Then go back to step 5.
7. After the setting is changed, press OK.
8. To finish, press “User Tools”.