SERVICE PROGRAM MODE
SM 4-61 A265/A267
Service
Tables
4.2.4 INPUT CHECK (SP5-803)
1. Access SP mode 5-803.
2. Select the number that will access the switch or sensor you wish to check (see
the table below).
3. Check the status of the sensor or switch.
4. If you wish to check the signal during a copy cycle, select the required copy
modes, then press the Start key. After that, re-enter the SP mode to monitor
the signal.
5. The LCD panel will display “00H” or “01H”. The meaning of the display is as
follows.
Input Check Table
Reading
Number Description
00H 01H
0 Not used
1 Front cover safety switch Closed Opened
2 Front cover safety switch – LD5 V Closed Opened
3 Right cover switch Closed Opened
4 Right lower cover switch Closed Opened
5 Tray Cover (optional paper tray unit) Closed Opened
6
Duplex unit open switch
(Optional duplex unit)
Closed Opened
7 Right upper cover switch Closed Opened
8
Right guide switch
(Optional bridge unit)
Closed Opened
9
Left guide switch
(Optional bridge unit)
Closed Opened
10 Not used
11 Paper overflow sensor Paper not detected Paper detected
12 ~ 15 Not used
16 Upper relay sensor Paper not detected Paper detected
17 Lower relay sensor Paper not detected Paper detected
18
Vertical transport sensor
(Optional paper tray unit)
Paper not detected Paper detected
Prev. Next OK Back
Input Check
Code: 5
[Serviceman P-Mode]
A250M501.WMF
To Next Page
Loading...
