Ricoh Aficio 270 - User Level Programming

USER LEVEL PROGRAMMING
A265/A267 1-4 SM
1.2 USER LEVEL PROGRAMMING
The following items can be programmed by the key operator. Make sure that the
items are programmed correctly.
ISDN PSTN
Item
G4 G3 G3
Remarks
Transfer report:
G3 direct number
!
Used for transfer request operations in
G3 PSTN communications
Transfer report:
G4 fax number
!!
Used for transfer request operations in
ISDN communications
G3-1 analog line:
CSI
!
Used to identify the terminal in G3
DIS/DCS communications over the
PSTN1.
G3-2 analog line:
CSI
!
Used to identify the terminal in G3
DIS/DCS communications over the
PSTN2.
G3 digital line:
Own fax number1
!
G3 digital line:
Own fax number2
!
When not using MSN* service:
Program the ISDN subscriber number
here. If an another terminal is on the
same bus from the DSU, identify the
terminals using a sub-address.
When using MSN* service:
Program the dedicated ISDN number
for the terminal as the 1st ISDN
subscriber number. If the customer
wishes the machine to answer calls to
two different numbers, program the
second number as the 2nd subscriber
no.
G3 digital line:
Sub-address
!
Program a sub-address to identify the
terminal, if two or more terminals
answer the call to the same subscriber
number for G3 fax.
G3 digital line:
CSI
!
Used to identify the terminal in G3
communications over an ISDN.
G4 digital line:
Own fax number1
!
G4 digital line:
Own fax number2
!
When not using MSN* service:
Program the ISDN subscriber number
here. If an another terminal is on the
same bus from the DSU, identify the
terminals using a sub-address.
When using MSN* service:
Program the dedicated ISDN number
for the terminal as the 1st ISDN
subscriber number. If the customer
wishes the machine to answer the
calls to two different numbers,
program the second number as the
2nd subscriber no.
G4 digital line:
Sub-address
!
Program a sub-address to identify the
terminal, if two or more terminals
answer the call to the same subscriber
number for G4 fax.
G4 digital line:
TID (Terminal ID)
✔
Used to identify the terminal in G4
communications.