Scanner Unit
A844
SERVICE PROGRAM MODE
SM 18-9 A265/A267
4. SERVICE TABLE
4.1 SERVICE PROGRAM MODE
4.1.1 SERVICE PROGRAM ACCESS PROCEDURE
The service program access procedure, such as “Entering Service Program (SP)
Mode” and “Exiting SP Mode” is the same as for copier and fax, as follows.
Entering SP mode
(
→
)
→
*
→
+
→
,
(hold it for more than 3 seconds.)
Exiting SP mode
Press the “Back” and “Exit” keys until the standby mode display appears.
4.1.2 SERVICE PROGRAM MODE TABLES
NOTE:
1) In the Function column, comments are in italics.
2) In the Settings column, the default value is in bold letters.
No. Function Setting
Changes the FTP port number.001 FTP Port Number
After changing this value, do the
following:
1. Run the Registry Editor.
2. Access
/HKEY_LOCAL_MACHINE/SO
FTWARE/Ricoh/NetworkScann
er
3. Change the value of PortNo to
this SP mode’s value.
0000 ~ 9999
1 / step
3670
002 Compression Type
Selects the compression type for
binary picture processing.
0: MH
1: MR
2: MMR
003 Software Version Displays the software version.
004 Program Number Displays the program’s part
number.
Displays the error logging data005 Error Log Display
Check this data when SC4005
occurs. Then inform it to the
service center.
Resets all scanner data (UP and
SP modes) except for the network
interface data (UP-Network-1 ~ 8)
006 Scan Data Reset
Press “1” three times to reset.
Resets all UP and SP settings007 All Data Reset
Press “1” three times to reset.
To Next Page
Loading...
