CONTROLLER FUNCTIONS
A265/A267 2-4 SM
Manual Tray Select
When the printer driver specifies a tray, the selected tray becomes the first tray
checked at the start of the tray search. If the selected tray does not have the size
and type of paper specified by the driver, the controller searches the other trays for
the same paper size and paper type.
NOTE:
Tray Priority in the Job Control menu does not specify the start of the tray
search, but specifies the paper size in the selected tray as the default
paper size.
Tray Lock
If Tray Lock is enabled for a tray, the controller does not use the “locked” tray in the
tray search process. If a tray has, for example, colored A4 size paper for fax prints,
enable tray lock for that tray so that the controller does not select the tray for
printing.
If the printer driver selects a “locked” tray, the controller uses the tray for printing
only when the specified paper size matches the actual paper size in the tray.
By-pass Tray
The by-pass tray is not part of the automatic tray search. To print from the by-pass
tray, the user has to select the by-pass tray (using either the driver or operation
panel). Even if the by-pass tray is empty, the controller will not switch to another
tray; the message on the LCD asks the user to add paper to the by-pass tray.
NOTE:
Collation and duplex are disabled when the by-pass tray is selected.
Tray 1
Tray 2
Tray 3 (optional)
Start of Tray Search
(Tray selected by the driver)
Tray 4 (optional)
B306D502.WMF
To Next Page
Loading...
