OPTIONAL UNITS
A265/A267 3-18 SM
3.2.5 EXPANSION MEMORY (EXMEM) BOARD
1. Remove the small cover [A] (1 rivet) and the rear cover [B] (4 screws).
2. Remove the FCU unit [C].
3. Install the EXMEM board [D] as shown. Tilt the EXMEM board so that it is at an
angle to the FCU, and slide it into the slot as shown. If the fax unit is being
installed at the same time, turn SW3 on the FCU board on.
4. Replace the FCU unit.
5. Replace the rear cover and the small cover.
A895I502.WMF
A895R253.WMF
A895I503.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
