SERVICE TOOLS
A265/A267 4-6 SM
4.4 SERVICE TOOLS
4.4.1 HDD TEST
This verifies the file and directory entries on the hard disk drive.
1. Enter the Printer SP mode, and select “2. Service Tool”.
2. Select “HDD Test”, then press [Enter].
3. Specify the number of tests, then press [Enter].
• If “000” is specified, the test will continue until it is manually cancelled.
• [UP] [DOWN]: Increment/decrement the digit at the cursor.
• [Cancel]: Exit without executing the test. Cancels the test even while it is
being executed.
• [Enter]: Execute the test.
4. Check the result of the test, then do the following:
• If the result is OK, press [Enter] to display the available free space on the
HDD. Then press [Enter] again to exit.
• If the result is NG, press [Enter] to do the test again. Or, press [Cancel] to
exit.
Error Display Details
Number at the top right corner Indicates that the error was found in the n’th
test.
Error Message “NG clstr error”
A damaged cluster was found. The damaged
cluster was marked as “bad” to avoid future use.
To Next Page
Loading...
