Ricoh Aficio 270 - Hot Roller and Fusing Lamp

FUSING/EXIT
SM 6-19 A265/A267
Replacement
Adjustment
6.5.4 HOT ROLLER AND FUSING LAMP
1. Remove the fusing unit. (See Fusing Unit.)
2. Remove the fusing upper cover. (See Thermofuse.)
3. Remove the pressure springs. (See Thermofuse.)
4. Remove the hot roller stripper bracket. (See Thermofuse.)
5. Remove the fusing lamp (2 screws) and hot roller assembly [A].
NOTE:
Do not touch the surface of the fusing lamp with bare hands.
6. Replace the hot roller [B] (2 C-rings, 1 gear, 2 bushings).
NOTE:
1) Before installing the new hot roller, peel off 3 cm (1 inch) from both
ends of the protective sheet on the new roller.
2) Do not touch the surface of the rollers.
3) When reinstalling the fusing lamp, secure the front screws first.
4) Be careful not to damage the surface of the hot roller.
A267R505.WMF
A267R506.WMF
[A]
[B]