COPIER INSTALLATION
A265/A267 3-10 SM
12.
If the optional bridge unit will not be installed:
Swing the sensor feeler [A]
out.
13. Install the optional ARDF or the optional platen cover (see ARDF Installation or
Platen Cover Installation).
14. Plug in the machine and turn the main power switch on. The machine
automatically performs TD sensor initial setting (approximately 45 seconds).
15. Select the correct display language using SP 5-808 or UT mode (Language).
16. Check the copy quality and copying functions.
17. Initialize the electrical total counter using SP7-825, depending on the service
contract type.
NOTE:
Select 1, then press the Original Type and OK keys at the same time. If
the reset is successful, the beeper sounds 5 times.
A267I105.WMF
[A]
To Next Page
Loading...
