SHIFT TRAY
SM 3-27 A265/A267
Installation
4. Install the stepped screw [A].
5. Install the shift tray unit [B], as shown.
NOTE:
1) Set the shift tray on the stepped screw.
2) The shift tray must be installed under the paper guide [C] installed in
step 3.
6. Connect the cable [D] to the copier.
7. Turn on the main power switch. Then select the shift tray using the UT mode
“2. Copier – 3. Input/Output – 6. Sort – Shift Sort”.
8. Check the shift tray operation.
B313I103.WMF
[A]
[B]
[D]
[C]
To Next Page
Loading...
