DUPLEX UNIT INSTALLATION
A265/A267 3-32 SM
6. Set the duplex unit [A] on the unit holder [B] or on the by-pass tray unit if it has
already been installed.
7. Attach the link [C] to the shaft [D] and secure it with the clip.
8. Connect the cable [E] and install the connector cover [F] (1 screw).
9.
If the by-pass tray has already been installed, skip this step:
Install the unit
holder cover [G] (2 screws).
10. Turn on the main power switch and check the duplex unit function.
A896I104.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
To Next Page
Loading...
