FAX UNIT
A265/A267 3-6 SM
11. Affix the super G3 decal [A] and attach the cover [B] on the front cover as
shown.
NOTE:
The cover [B] is for European, Asian, Chinese and Taiwanese models
only.
12. If the ADF has been installed, insert the stamp cartridge [C] into the ADF as
shown.
13. Connect the telephone line to the “LINE” jack at the rear of the machine.
14. Plug in the machine and turn on the main power switch.
15. Press the “Facsimile” key. At this time, the display shows: SC1201 - Functional
problem with the fax. Data should be initialized.
NOTE:
This is not a functional problem. The machine shows this message only
when the fax unit is first installed. If the same message appears at the
next power on, check whether the battery switch (SW3) on the FCU
has been turned on.
16. Press “Yes” to initialize the fax unit.
17. Remind the user to program the items required for fax communications.
•
RTI for PSTN-1
•
TTI-1, TTI-2
•
Own telephone number (for transfer result reports)
•
Telephone line type
18. If the user function keys (F1, F2, F3, F4) need to be programmed, attach a
label.
The default settings for the user function keys are as follows:
*F1: Start Manual Rx
*F2: TEL Mode
*F3: Tx Result Display
*F4: Not programmed
19. Be sure to set the clock. (Date and time)
20. Program the serial number into the fax unit (service function 10). The serial
number can be found on the serial number label (attached to the machine in
step 10).
A895I258.WMF
A895I552.WMF
[B]
[A]
[C]
To Next Page
Loading...
