OPTIONAL UNITS
SM 3-13 A265/A267
Installation
A895
7. Replace the rear cover and the small cover.
8. Connect the cable to the ISDN jack, then plug in the machine and turn the main
switch on.
9. Enter service mode and set bit 2 of communication switch 16 to "1". After that
turn the main switch off and on.
10. Print the system parameter list and ensure that "G4" is listed as an option.
11. Program the items required for ISDN communications (refer to the ISDN kit
service manual). After setting up the ISDN parameters, be sure to turn the main
switch off and on.
NOTE:
The default settings for the user function keys with a G4 unit are as follows.
F1: Start Manual Rx
F2: TEL Mode
F3: Tx Result Display
F4: G3/G4 communication Mode Selection
To Next Page
Loading...
