Ricoh Aficio 270 - Page 629

BIT SWITCHES
A265/A267 4-30 SM
System Switch 1F
No FUNCTION COMMENTS
0
Not used Do not change the setting.
1 Report printout after an
original jam during SAF
storage or if the SAF memory
fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory
overflows during scanning, a report will be
printed.
Change this bit to “1” if the customer does not
want to have a report in these cases.
Memory tx – Memory storage report
Parallel memory tx – Transmission result report
2
Not used Do not change the setting.
3
Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
4
Received fax print start timing
(G4 reception)
0: After receiving each page
1: After receiving all pages
0: The machine prints each page immediately
after the machine receives it.
1: The machine prints the complete message
after the machine receives all the pages in the
memory.
5-6
Not used Do not change the factory setting.
7
Action when a fax SC has
occurred
0: Automatic reset
1: SC code display
0: When the fax unit detects a fax SC code other
than SC1201 and SC1207, the fax unit
automatically resets itself.
1: When the fax unit detects any fax SC code, the
fax unit displays the SC code and stops.
Cross Reference
Fax SC codes - See “Troubleshooting”, section
7.1.