Ricoh Aficio 270 - Page 632

BIT SWITCHES
SM 4-33 A265/A267
Service
Tables
A895
Scanner Switch 0B
No FUNCTION COMMENTS
0
to
3
Scan margin setting (top and bottom margin in book scan mode, and top margin in
ADF mode)
The setting can be between 0 and F (H) (in mm).
Default setting: 3 mm
4
to
6
Scan margin setting (bottom margin in ADF mode)
The setting can be between 0 and 7 (H) (in mm).
Default setting: 2 mm
If the scanned image margin is still incorrect after adjustment, the base copier’s SP
mode settings may be wrong. Check and adjust SP mode 6-006-3.
7
Not used Do not change the setting.
Scanner Switch 0C
No FUNCTION COMMENTS
0
Action when an original jam
has occurred while scanning
the original into memory for
memory tx
0: Continues scanning after
recovery
1: Stops scanning and erases
all scanned pages for that job
This bit is only effective when parallel memory tx
is disabled (user parameter 07 - bit 2).
If parallel memory tx is enabled, the machine
always erases the scanned pages when an
original jam occurs. The machine then asks the
user to retry from the first page, even if the
parallel memory tx is not actually used.
0: The machine displays a message asking the
user to put the jammed page back into the original
stack, and continues scanning.
The message is displayed for the time period
specified by scanner switch 0E, bit 2.
1: The machine erases all the scanned pages and
asks the user to retry from the first page.
1
to
2
Setting when an original size
cannot be recognized
Bit 2 1 Setting
0 0 Depending on
the copier’s setting
0 1 A5
5
1 0 A5
6
1 1 No original
When both bits are set to “0”, the machine
recognizes an original size depending on SP4-
303 in copier service mode.
3-5
Not used Do not change the settings.
6 Scan width used for a
document set in the ADF
when the width is less than
230 mm.
0: A4 (210 mm)
1: LT (216 mm)
This bit is set at “1” when the country code is set
to the US.
7
Not used Do not change the setting.
Scanner Switch 0D