BIT SWITCHES
SM 4-59 A265/A267
Service
Tables
A895
G3 Switch 0C
No FUNCTION COMMENTS
0
1
Pulse dialing method
Bit 1 Bit 0 Setting
0 0 Normal(P=N)
0 1 Oslo (P=10 - N)
1 0 Sweden
(N+1)
1 1 Not used
P = Number of pulses sent out, N = Number
dialed.
2-7
Not used Do not change the settings.
G3 Switch 0D
No FUNCTION COMMENTS
0-1
Not used Do not change the settings.
2
to
5
Data rate threshold during
V.34 reception
Bit5432Setting
0000 Normal
0111Lower by
one step
1111Lower by
two steps
The machine changes the modulation parameters
in the MPh signal to lower the initial modem rate
during V.34 reception. If this switch is set to
“0111”, the machine lowers the initial speed one
step, for example, from 28,800 to 26,400 bps.
This switch reduces transmission time if the
machine frequently sends PPR signals during
V.34 reception.
6
Not used Do not change the setting.
7 B signal detection time for
V.34 polling transmission
0: 75 ms (default setting)
1: 65 ms
Change this switch only when there are
communication errors during V.34 polling
transmission to a machine with a Panasonic
modem.
G3 Switch 0E - Not used (do not change the settings)
G3 Switch 0F
No FUNCTION COMMENTS
0 Alarm when an error occurred
in Phase C or later
0: Disabled
1: Enabled
If the customer wants to hear an alarm after each
error communication, change this bit to “1”.
1
Alarm when the handset is
off-hook at the end of
communication
0: Disabled
1: Enabled
If the customer wants to hear an alarm if the
handset is off-hook at the end of fax
communication, change this bit to “1”.
2
to
3
G3 switch 0F
Bit 3 Bit 2 Settings
0 0 32 sec
0 1 40 sec
1 0 50 sec
1 1 60 sec
In order to ensure that the NSF/DIS signals (from
the machine tat is to receive the facsimile) will
successfully be received by the sender, the
transmission duration of these signals can now be
extended.
4-7
Not used Do not change the settings.
Rev. 02/2000
⇒
⇒⇒
⇒
To Next Page
Loading...
