SERVICE RAM ADDRESSES
SM 4-85 A265/A267
Service
Tables
A895
6800C4(H) - User parameter switch 04 (SWUSR_04: Automatic report
printout)
Bit 0: Automatic confidential reception report output 0: Off, 1: On
Bits 1 to 6: Not used
Bit 7: Inclusion of a sample image on reports 0: Off, 1: On
6800C5(H) - User parameter switch 05 (SWUSR_05)
Bit 0: Substitute reception when the base copier is in an SC condition
0: Enabled, 1: Disabled
Bits 1 and 2: Condition for substitute rx when the machine cannot print messages
(Paper end, toner end, jam, and during night mode)
Bit 2 1 Setting
0 0 The machine receives all the fax messages.
0 1 The machine receives the fax messages with RTI or CSI.
1 0 The machine receives the fax messages with the same ID code.
1 1 The machine does not receive anything.
Bit 3: Not used
Bit 4: Restricted Access using personal codes 0: Off, 1: On
Bit 5: Just size printing 0: Off, 1: On
Bit 6: Not used
Bit 7: Add paper display when a cassette is empty 0: Off, 1: On
6800C6(H) - User parameter switch 06 (SWUSR_06)
Bit 0: Not used
Bit 1: G3/G4 LED home position 0: G3, 1: G4
Bits 2 and 3: G3 line type home position
Bit 3 2 Setting
0 0 G3 auto selection
0 1 PSTN-1
1 0 PSTN-2 (only available if the optional SG3 board is installed)
1 1 Not used
Bit 4: Quick dial label print format
0: Suitable for white paper, 1: Suitable for transparent paper
Bit 5: Not used
Bit 6: Scan sequence in Book transmission
0: Left page then right page, 1: Right page then left page
Bit 7: Not used
6800C7(H) - User parameter switch 07 (SWUSR_07)
Bits 0 and 1: Not used
Bit 2: Parallel memory transmission 0: Off, 1: On
Bits 3 to 7: Not used
6800C8(H) - User parameter switch 08 (SWUSR_08)
Bits 0 and 1: Not used.
Bit 2: Authorized reception
0: Only faxes from senders whose RTIs/CSIs are specified for this feature
are accepted.
1: Only faxes from senders whose RTIs/CSIs are not specified for this feature
are accepted.
Bits 3 to 7: Not used.
To Next Page
Loading...
