SERVICE TOOLS
A265/A267 4-8 SM
7. Turn on the machine, and ensure that the target NIB is correctly installed.
8. Enter the Printer SP mode, and select “2. Service Tool”.
9. Select “NIB read/write”, then press [Enter].
10. Select the data copy direction “CTL -> NIB”, then press [Enter].
• [UP] [DOWN]: Select a data copy direction.
• [Cancel]: Exit.
• [Enter]: Copy the NIB NVRAM to the controller.
NOTE:
Once data copying has started, it cannot be cancelled.
11. Check the result, then do the following:
• If the result is OK, press [Enter] to exit.
• If the result is NG, check the error message, then press [Enter] to exit.
Error Display Details
Error Message “NG copying”
NIB data copying failed. Try again.
To Next Page
Loading...
