FIRMWARE UPDATE
A265/A267 4-10 SM
5. Check the firmware version as follows:
1) Controller and NIB Firmware
• CARD: Firmware version on the card
• ROM: Current controller or NIB firmware version
2) PS3 DIMM
• DIMM: Current PS3 firmware version
• CARD: Firmware version on the card
6. Start downloading the new firmware.
1) Controller and NIB Firmware
• Press [Execute] to download the new firmware.
• Press [Cancel] to exit.
2) PS3 DIMM
• Press [Execute] to download.
• Turn off the machine to cancel.
7. After the firmware download has finished, turn off the machine, and remove the
card. Then, re-install the cover [A].
8. Turn on the machine, and print the service summary report to confirm that the
new firmware version has been installed.
Error Messages
Message Description Controller NIB PS3
Erasing Failed ADRS:
xxxxxx
Yes Yes Yes
Writing Failed ADRS:
xxxxxx
Test the on-board flash ROM and
retry the download.
Yes Yes Yes
Memory Insufficient Reset the controller and try again. Yes Yes Yes
Melting Failed The firmware file used to program
the card may be damaged. Get a
new firmware file and store it on
the card.
Yes Yes No
DIMM – installable
program cannot find
Wrong type of firmware on the
card.
No No Yes
CRC error: Please
retry install
The firmware file used to program
the card may be damaged. Get a
new firmware file and store it on
the card.
No No Yes
NIB board is not
equipped
Install a NIB on the controller, then
try again.
No Yes No
Initialization failed Retry the download. No Yes No
Download mode is
disabled
Retry the download. No Yes No
To Next Page
Loading...
