Ricoh bk5010 - Page 113

Replacement
Adjustment
21 August 2006
Replacement
Adjustment
3-27
AREA A
Removal Sensor Q3
1. Remove Infeed cover (
3.3.2 ).
NOTE: Picture shows Infeed module removed for clarity. It is not necessary to
remove Infeed module to replace Sensor Q3.
2. Disconnect connector [A] to Sensor Q3 (
x1 ).
3. Remove sensor Q3 [B].
Replacement Sensor Q3
1. Reverse the removal procedure.
Removal Back jogger module
1. Remove Infeed module (
3.4.1 ).
2. Remove Infeed transport module (
3.4.3 ).
3. Remove the screw to plastic distance [C] (
x1 ).
4. Unhook the Length adjustment strap wheel [D].
NOTE: DO NOT TURN THE ADJUSTMENT SCREW.
5. Insert a screwdriver [E] in the shaft and unscrew the shaft [F] to the Back jog
-
ger module ( x1 ).
NOTE: Rotate the screwdriver counterclockwise to unscrew the shaft.
6. Remove the shaft [F].
7. Remove the Back jogger module.
NOTE: If removing the Back jogger module completely, remove three cable
ties to the Infeed sensor Q1 harness.
Replacement Back jogger module
NOTE: When replacing the Back jogger module, make sure that the Back jogger
ngers [G] and the Infeed bearing bracket [H] is in its right position.
1. Reverse the removal procedure.