Ricoh bk5010 - Page 86

2-2
19 April 2006 PM TABLE
TR5010 125K 250K 375K 500K NOTE REFERENCE
Paper paths C C C C Blower Brush
Sensors C C C C Blower Brush
Infeed module
Infeed belts (4x) C C C R Alcohol 3.2.20
Outfeed module
Upper outfeed belts
(2x)
C C/ I C C/ I Alcohol 3.2.15
Lower outfeed belts
(2x)
C C/ I C C/ I Alcohol 3.2.14
Trim Knife
Trim knife I I I I Inspect 3.2.8
Drive
Knife chain L L L L Launa Oil 40 3.2.19
Knife support chain L L L L Launa Oil 40 3.2.18
Transmission chain /
Chain sprockets
L L/ I L L/ I Launa Oil 40 3.2.17
Gear rack L L Grease 501 3.2.10
BF5010 250K 500K NOTE REFERENCE
All machine, paper
path etc.
C C Blower brush.
Sensors. C C Blower brush.
Transport belt. C/I/R C/I/R Alcohol. 3.4.1 & 3.4.2
Pressure roller. I/R I/R Inspect O-rings and
pressure roller*.
Change position of
wear point of pressure
roller. Replace Com-
plete assy if needed.
3.2.4
Link Arms for
Clamps.
I/R I/R Inspect Link Arms
for wear. Replace if
needed.
3.5.1
Lower Clamp L L Check that the lower
Clamp moves, when
pressed by upper
Clamp. Grease 501.
3.5.1
Upper Clamp L L Grease 501. 3.5.1
Brass Guides L L Grease 501. 3.5.1
Teon Tape I/R I/R Inspect, Replace if
needed.
3.4.3
Dampers R R Replace dampers.
Adjust stop gage
3.5.2
* To prevent atness of pressure roller.