10 February 2005 SD CARD APPLICATION MOVE
5-131
Service
Tables
Move Exec
Do this procedure to move an application from one SD card to another.
1. Turn the main switch off.
2. Put the destination SD card in SD Card Slot 1.
3. Put the source SD card into SD Card Slot 3. This SD card holds the application
program that you want to copy to the destination SD card in Slot 1.
4. Turn the main switch on.
5. Go into the SP mode.
6. Do SP5873-001 “Move Exec.”
7. Obey the messages on the operation panel to complete the procedure.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 3.
10. Turn the main switch on.
11. Check that the application programs combined on the SD card in Slot 1 operate
correctly.
Undo Exec
Do this procedure to repair the original source SD card if you accidentally move the
application to a different SD card.
1. Turn the main switch off.
2. Put the original source SD card in SD Card Slot 3. The application program is
copied back into this card.
3. Put the original destination SD card (with the stored application program that
you want to return to the original source SD card in Slot 3) in SD card Slot 1.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-002 (Undo Exec)
6. Obey the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the SD card from SD card Slot 3
9. Turn the main switch on.
10. Check that the application programs run correctly.
To Next Page
