10 February 2005 PRINTER OPTIONS
1-55
Installation
1.15.5 IEEE802.11B (G813)
!CAUTION
Unplug the main machine power cord before starting the following
procedure.
NOTE: You can only install one of the following network interfaces at the same
time: IEEE 802.11b (Wireless LAN), IEEE1284 (Parallel/Centronics),
IEEE1394 (FireWire), Bluetooth.
1. Remove the slot cover [A] from I/F Card Slot B (! x 2).
2. Attach the wireless LAN board [B] to the controller board (Knob-screw x 2).
NOTE: Use a screwdriver when you tighten the knob-screws. Do not tighten
them manually. It can cause this board to disconnect from the machine.
3. Install the wireless LAN card [C]. The printed side must point to the front of the
machine.
4. Attach the antenna cap [D].
G813I001.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
