SPECIFICATIONS 10 February 2005
Spec-2
Zoom: 25% to 400% in 1% steps (Platen mode)
25% to 200% in 1% steps (ADF mode)
Scanning System: 3-line 1-chip CCD sensor (600 dpi)
Light Source: 1 xenon lamp
Photoconductor: OPC belt
Charging: Corona wire with grid plate
Print System: Two laser beam, 600 dpi
Development System: Mono component toner
Transfer: Image transfer: Transfer belt with bias roller
Paper transfer: Roller
Separation: Discharge pin
Fusing: Heating rollers and fusing belt
Cleaning: OPC belt: Blade
Image transfer belt: Cleaning brush
Quenching: Lamp
Toner Supply: Cartridge
Power Source:
Voltage Frequency Amperage
NA 100 to 120 V 50/60 Hz 12 A
EU & Asia 220 to 240 V 50/60 Hz 8 A
Power Consumption:
Mainframe only Full System
Maximum: Less than 1.5 kW Less than 1.5 kW
Copying: Less than 1.2 kW Less than 1.3 kW
Stand-by: Less than 200 W Less than 200 W
Auto Off: 5.7 W 15.5 W
NOTE: Full system: ARDF + 1 bin tray + Paper Tray Unit + Duplex Unit + Bridge
Unit +1000-sheet Finisher
Noise Emission:
Mainframe only Full System
Stand-by: Less than 40 dB (A) Less than 40 dB (A)
Copying: Less than 65 dB (A) Less than 70 dB (A)
NOTE: Full system: ARDF + 1 bin tray + Paper Tray Unit + Duplex Unit + Bridge
Unit +1000-sheet Finisher
Dimensions (W x D x H):
NA: 640 x 682 x 945 mm (25.2” x 26.85” x 37.2”)
EU/CHN: 550 x 682 x 781 mm (21.65" x 26.85" x 30.74")
ASIA: 550 x 682 x 945 mm (21.65" x 26.85" x 37.2”)
Weight:
NA: Less than 106 kg (234 lb)
EU/CHN: Less than 88 kg (197 lb)
ASIA: Less than 98 kg (220 lb)
To Next Page
