RKC INSTRUMENT PF900 User Manual

5. OPERATION
IMR02L04-E3
5-28
5.6.3 Connections for loader communication
Connect PF900/901, COM-K and the personal computer by using the USB cable and loader communication
cable. Confirm the orientation of the connector before connecting the cables.
Both loader communication ports cannot be used at the same time.
 Communication port of host computer
USB port: Based on USB Ver. 2.0
 Communication settings on the computer (Values other than the communication port are fixed.)
Communication speed: 38400 bps
Start bit: 1
Data bit: 8
Parity bit: Without
Stop bit: 1
 The device address for Loader communication is fixed at “0.”
The setting of the device address is disregarded.
 When using the loader communication port in front
Use COM-K communication converter and W-BV-03 loader communication cable.
Turn ON the PF900/901 first when using the loader communication port in front.
 When using the loader communication port at the bottom
Use COM-K communication converter and W-BV-01 loader communication cable.
PF900/901 may be OFF when using the loader communication port at the bottom.
USB cable 1 m
(COM-K accessory)
Connected to loader
communication
connector of the
PF900/901
Connected to USB
port of a personal
Loader communication
cable 1.5 m (W-BV-01)
[COM-K-1 accessory]
Connected to
loader
Connected to
USB connecter
Loader
communication
connector
PF900/901
bottom view
USB communication
converter
COM-K
USB communication
converter
COM-K
USB cable 1 m
(COM-K accessory)
Connected to loade
r
communication
connector of the
PF900
/
901
Connected to USB
port of a personal
computer
Loader communication
cable 1.5 m (W-BV-03)
[COM-K-3 accessory]
Connected to loade
r
communication
Connected to
USB connecter
Loader
communication
connector
RESET
RUN
FIX MAN HOLD STEP R.SET
PTN END
MONI MODE
SET
PF900
PV
TM H:M:S SV
28
$
40
:
00 200
!

PTN
SEG
DO
1

1

PF900/901
front view

RKC INSTRUMENT PF900 Specifications

General

Brand	RKC INSTRUMENT
Model	PF900
Category	Controller
Language	English