4. BASIC OPERATION
IMR02L04-E3
4-17
Parameter list [Partial setting type]
For parameter switching, refer to P. 4-22 to 4-25.
Name Symbol Data range
Factory set
value
Program setting block (
PROG
)
Setting pattern number
PTN.NO
1 to 99 (Within the maximum pattern number)
1
Segment level
LEVEL
Setting limiter low to Setting limiter high
0
Segment time
TIME
From 0:00 to 500:00 (Hour: Minute), or
from 0:00 to 500:00 (Minute: Second)
0 hour
00 minute
Segment repeat start/end number
ST‹ED
Start number: 1 to 99
End number: 1 to 99
Within the maximum segment number
1
Segment repeat execution time
RPT.SG
1 to 9999 times
1: No segment repeat
1
Pattern repeat execution time
RPT.PN
1 to 10000 times
1: No pattern repeat
10000: No limit
1
Link pattern number
LNK.PN
0 to 99 (Within the maximum pattern number)
0: No pattern link
0
Pattern end output duration
END.TM
From 0:00 to 500:00 (Hour: Minute), or
from 0:00 to 500:00 (Minute: Second)
Output remains ON at 0:00 (Hour: Minute or
Minute: Second)
0 hour
00 minute
Time signal memory group number
P TS.GR
0 to 16
0: No assignment
1
Output program memory group
number
P.MV.GR
0 to [128/Maximum number of segments]
Up to 99
0: No assignment
0
Program memory group setting block (PR.MEM)
Setting pattern number
PTN.NO
1 to 99 (Within the maximum pattern number)
1
PID memory group number
PID.GR
0 to 8
0: Level PID
0
Event memory group number
EV.GR
0 to 8
0: Event OFF
1
Wait memory group number
WT.GR
0 to 8
0: Wait OFF
1
Continued on the next page.
Press the
key to switch setting screen.
Setting block may be switched by using the
key or
the
key.
Press the STEP R.SET key to go back to the previous
display.
Press the STEP R.SET key while pressing the
key
to go back to the first setting display of the setting block.
PV/SV monitor
Parameter setting mode
Press and hold the key for
2 seconds or more.
Press the
key or Press the
key while pressing the
key.
To Next Page
Loading...
Need help?
General
