4. BASIC OPERATION
IMR02L04-E3
4-27
Parameter switching [Batch setting type]
To go to the Parameter setting mode, press and hold the
key for 2 seconds or more at PV/SV monitor
display.
Press the
key to switch operation screen.
Switch setting block by using the
key or the key.
Press the
key to go back to the PV/SV monitor.
Press the STEP R.SET key to go back to the previous display.
Press the STEP R.SET key while pressing the
key to go back to the first setting display of the
setting block.
Display returns to the PV/SV monitor if no key operation is performed within 1 minute.
PV
PTN.NO
M:S
SV
53000000001
PV/SV monitor
PV
00028
$
M:S
SV
5 30:00000200
Program
setting block
PV
PROG
M:S
SV
30000000200
Setting pattern
number
Setup setting mode
Go to the setting display of the next segment.
Program end
PV
P P.END
M:S
SV
53000000001
PV
LEVEL
$
M:S
SV
5 30:000 00200
PV
L TIME
M:S
SV
030:00000200
Segment level
Segment time
PV
PID.GR
M:S
SV
53000000000
PID memory group
number
PV
P EV.GR
M:S
SV
53000000001
Event memory group
number
PV
L WT.GR
M:S
SV
F60.01R00001
Wait memory group
number
PV
SIGNL
M:S
SV
RES00000000
Segment signal
(Displays when the Segment
signal is selected.)
PTN END
PID memory group
setting block
Continue to the parameter on the next page.
PTN END
Press and hold the
key
for 2 seconds or more.
Press and hold the
key
for 2 seconds or more.
Press the STEP R.SET key
while press the
key.
fter setting all segments being set
at the Maximum pattern/segment
number in the Engineering mode.
fter setting the last segment
being set by the Program end.
Set Program end
(to limit the segment
numbers).
Release Program
end to go to the next
segment setting
display.
(P. 4-26)
To Next Page
Loading...
Need help?
General
