RKC INSTRUMENT PF900 User Manual

5. OPERATION
IMR02L04-E3
5-11
5.4 Program Control Operation
5.4.1 Program control mode display
Set Alarm lamp light condition at F10 in the Engineering mode
(P. 4-32).
Set DO type at F34 in the Engineering mode (P. 4-38).
Set parameter for Program pattern display at F10 in the Engineering mode.
For Program pattern display, refer to 6.3.1 Graph display selection of the PF900/PF901
Instruction Manual (IMR02L03-E) on the CD-ROM.
Refer to 6.8 Pattern End (P. 6-17) for the display of Segment remaining time monitor at Pattern
end.
PV
H:M:S SV
††200
$
M 34:500

200
!

DO
A
T
REM
TS
OUT1
OUT2
OUT3
1 23456
7
8 9 10 11 12
A
LM
82
85
Segment level set value
Measured value (PV)
(Displays character of parameter
at setting.)
Lights when the settings are
locked.
Input unit display
Lights during AT.
Gradient state lamp
(Lights the lamp of the gradient in
process.)
Lights when the output (OUT1 to
OUT3) corresponding to each
lamp is ON.
Lights conforming to Alarm lamp
light condition.
Lights conforming to DO state.
Program pattern display *
Displays segment level of pattern (up to 20 segments).
The level of each dot is one tenth of the value between
Dot monitor scale low to Dot monitor scale high.
PV/SV monitor
20 segments
Level of dot:
One tenth of the value between Dot monito
r
scale low to Dot monitor scale high
Segment in progress flashes at RUN state.
Displays pattern numbe
r
and segment number.
Program time unit
Segment remaining time
(The character “END” flashes
at Pattern end.)
Lights when time
signal is turned on.
Dot monitor scale low
Dot monitor scale high
* To display Program pattern, select Program pattern type at Dot monitor type (DDTP) of F10.02
in the Engineering mode
(P. 4-32).
(Factory set value: Program pattern type)

RKC INSTRUMENT PF900 Specifications

General

Brand	RKC INSTRUMENT
Model	PF900
Category	Controller
Language	English