Receiver Mode R&S ESCI
1166.6004.12 4.2 E-2
RECEIVER
The RECEIVER hotkey sets the R&S ESCI in the test receiver mode.
IEC/IEEE-bus command: INST:SEL REC
MIXED
The MIXED hotkey sets the R&S ESCI in a combination of test receiver and
analyzer mode. The display is set to split screen.
IEC/IEEE-bus command: INST:CONF:MIX ON
INST:CONF1 REC
SCREEN A
With the SCREEN A / SCREEN B hotkey two different settings can be
selected on the R&S ESCI in the FULL SCREEN mode.
In the SPLIT SCREEN mode the key switches between active diagram A
and B.
The key designation indicates the diagram which has been activated by
means of the key.
The currently active window is marked by
A
or
B
on the right of the
diagram.
IEC/IEEE-bus command: DISP:WIND<1|2>:SEL A
The meaning of the other keys is described in the chapter describing the various options.
To Next Page
Loading...
