R&S ESCI Configuration/Setup
1166.6004.12 4.229 E-3
Enabling Firmware Options
The OPTIONS softkey opens a submenu that allows license keys for firmware options to be entered.
Previously installed options are displayed in a table that opens automatically.
IEC/IEEE-bus command: OPT?
OPTIONS
INSTALL
OPTION
Softkey INSTALL OPTION opens the data entry for the license keycode of a
firmware option.
On entry of a valid license key the message OPTION KEY OK is displayed in
the status line and the firmware option appears in table FIRMWARE
OPTIONS .
On entry of an invalid license key the message OPTION KEY INVALID is
displayed in the status line.
IEC/IEEE-bus command: --
REMOVE
OPTION
Softkey REMOVE OPTION removes all firmware options from the
instruments. Execution of this function must be confirmed in a message box
in order to avoid removal of the firmware options by mistake.
IEC/IEEE-bus command: --
To Next Page
Loading...
