Rohde & Schwarz EMI Test ReceiverESCI - Programming the Interface Configuration and Time Setup; Selecting the IEC;IEEE-Bus Address

Configuration/Setup R&S ESCI
1166.6004.12 4.220 E-3
Programming the Interface Configuration and Time Setup
The GENERAL SETUP softkey opens a sub-menu in which the general instrument parameters can be
set up. In addition to the configuration of the digital interfaces (IECBUS, COM), the date and time may
be entered.
The current settings are displayed in tabular form on the display screen where they may be edited.
SETUP submenu:
ON
STBY
PREV
NEXT
PRESET
SETUP
HCOPY
CAL
GPIB
SPECTRUM
SCREEN B
GENERAL
SETUP
FIRMWARE OPTIONS
TIME +
DATE
20
GPIB ADDRESS
TIME & DATE
TIME 14:38
DATE 23.JUN 1999
Baud
Bits
Parity
Stopbits
HW-Handshake
SW-Handshake
Owner
COM INTERFACE
COM
INTERFACE
9600
8
None
1
None
XON/XOFF
Instrument
CONFIGURE
NETWORK
NETWORK
LOGIN
USER PORT
RECEIVER
Selecting the IEC/IEEE-bus address
SETUP - GENERAL SETUP menu:
GPIB
The GPIB softkey opens a submenu for setting the parameters of the remote-
control interface.
IEC/IEEE-bus command: --
GPIB
ADDRESS
The GPIB ADDRESS softkey enables the entry of the IEC/IEEE-bus address.
Valid addresses are 0 through 30. The default address is 20.
IEC/IEEE-bus command: SYST:COMM:GPIB:ADDR 20
ID STRING
FACTORY
The ID STRING FACTORY softkey selects the default response to the *IDN?
query.
IEC/IEEE-bus command: --