R&S ESCI Recalling Data Sets
1166.6004.12 4.239 E-1
Storing a Device Configuration
Storing a Complete Device Configuration
The following steps are required to store a complete device configuration:
! Press the FILE key and then press the SAVE softkey.
The selection box for the device configuration will be opened:
! Enter the name of the data set to be stored (in the simplest case, a digit from 0 to 9) and press
ENTER. The data set will be stored and the dialog window closed.
The name of the data set may comprise letters and digits; if required, the desired directory may
precede the name of the data set (the directory will then automatically be used for further SAVE and
RECALL processes).
The help line editor, which can be opened by pressing the Cursor Down
key, is available for
entering file names via the front-panel keypad.
For further information on the operation of this editor, see section "Entering Text using the Help Line
Editor".
How to enter comments, change the path for the file to be stored and select the data set from a list is
described under the associated softkeys EDIT COMMENT, EDIT PATH and DATA SET LIST.
The default path for the device configuration is D:\USER\CONFIG. The file names of the data sets have
the extension .ESCI.
Storing Parts of a Device Configuration
To store part of a data set (e.g. "All Transducers"), the partial data set has to be selected beforehand.
The following steps are required:
! Press the FILE key and then the SAVE softkey.
! Press the ITEMS TO SAVE/RCL softkey. The entry focus moves to the first entry in the Items
field.
! Use the spinwheel to move the entry focus to the desired entry in the Items field and select the partial
data set by pressing the spinwheel or ENTER. The selection of already highlighted partial data sets
can be cancelled by pressing the spinwheel / ENTER again.
To Next Page
Loading...
