R&S ESCI External Generator Control - Configuration
1166.6004.12 4.288 E-1
Like the internal tracking generator, the external generator is activated by means of the NETWORK
hotkey in the hotkey bar at the screen bottom:
RECEIVER
SPECTRUM
NETWORK
SCREEN B
MIXED
External Generator Settings
The NETWORK hotkey opens the menu for setting the functions of the external generator.
SOURCE
CAL
NETWORK CAL
TRANS
EXT SRC
ON OFF
SELECT
GENERATOR
FREQUENCY
SWEEP
CAL REFL
SHORT
CAL REFL
OPEN
REF VALUE
POSITION
REF VALUE
NORMALIZE
RECALL
EXT
SOURCE
Note: Other softkeys are available in the displayed menus for controlling the internal tracking
generator when option Tracking Generator R&S FSP-B9 is fitted. For detailed information
see section "Option Tracking Generator R&S FSP-B9".
SOURCE
POWER
The SOURCE POWER softkey activates the entry of the generator output
level. The value range depends on the selected generator (See table of
chapter "Configuration of the External Generator").
Ist neben der Option Externe Generatorsteuerung B10 auch die Option
Mitlaufgenerator B9 installiert, so verändert der Softkey wahlweise den
Ausgangspegel des internen Mitlaufgenerators oder des externen
Generators, je nachdem, welcher Generator gerade eingeschaltet ist.
Die Grundeinstellung des Ausgangspegels ist -20 dBm.
IEC/IEEE-bus command: SOUR:EXT:POW –20dBm
To Next Page
Loading...
