R&S ESCI Configuration/Setup
1166.6004.12 4.233 E-3
Display of System Messages
SETUP SYSTEM INFO submenu:
SYSTEM
MESSAGES
The SYSTEM MESSAGES softkey opens a submenu including a table in
which the generated system messages are displayed in the order of their
occurrence. The most recent messages are placed at the top of the list.
The following information is available:
No Device specific error code
MESSAGE Brief description of the message
COMPONENT On hardware messages:
name of the affected module
On Software messages:
if needed, the name of the affected software
components
DATE/TIME Date and time of the occurrence of the message
Messages that have occurred since the last call to the SYSTEM MESSAGES
menu are marked with an asterisk '*'.
The CLEAR ALL MESSAGES softkey is activated and allows clearing of the
error buffer.
If the number of error messages exceeds the capacity of the error buffer, the
message appearing first is "Message buffer overflow".
COMPONENT
DATE/TIME
No of cycles
VCO unlock
Calamp range
3.3V: Voltage
I2C-Bus failed
01
02
03
04
05
05.Jan.99 10:02:00
05.Jan.99 10:01:30
05.Jan.99 10:00:50
04.Jan.99 15:58:10
04.Jan.99 15:58:05
MESSAGE
No
Attenuator
Frontend
IF Filter
Detector
CPU
SYSTEM INFO
IEC/IEEE-bus command: SYST:ERR?
CLEAR ALL
MESSAGES
The CLEAR ALL MESSAGES softkey deletes all messages in the table.
The softkey is only available when table SYSTEM INFO is active.
IEC/IEEE-bus command: SYST:ERR?
To Next Page
Loading...
