R&S ESCI Configuration/Setup
1166.6004.12 4.227 E-3
Configuration of network settings (with option FSP-B16 only)
The instrument can be connected to an Ethernet LAN (local area network) by means of the LAN
Interface Option FSP-B16. This allows data transmission via the network and the use of network
printers. The network card is able to handle both 10 MHz Ethernet IEEE 802.3 and 100 MHz Ethernet
IEEE 802.3u.
For more details see section 'LAN Interface - Option FSP-B16'.
SETUP - GENERAL SETUP - menu:
CONFIGURE
NETWORK
The CONFIGURE NETWORK softkey opens the dialog box with the
network settings.
The softkey is used to modify an existing network configuration after the
corresponding tabs are selected (see subsection "Configuration of Already
Installed Network Protocols" in the section describing the LAN Interface
FSP-B16) .
Notes: - A PC keyboard with trackball (or mouse instead) is required for
the installation/configuration of the network support.
- The softkey is only available with built-in LAN interface option
(FSP-B16).
IEC/IEEE-bus command: -
To Next Page
Loading...
