Connecting a Printer R&S ESCI
1166.6004.12 1.24 E-1
The factory setting for DEVICE 2 is "Clipboard". In this case, the printout will be copied to the
Windows XP clipboard which is supported by most Windows applications. The contents of the
clipboard can be pasted directly into a document via EDIT - PASTE.
Table 1-1 Factory settings for DEVICE 1 and DEVICE 2 in the HCOPY menu shows the factory
settings for the two output devices.
Table 1-1 Factory settings for DEVICE 1 and DEVICE 2 in the HCOPY menu
Setting Selection in
configuration table
Setting for DEVICE 1 Setting for DEVICE 2
Output device DEVICE WINDOWS METAFILE CLIPBOARD
Output PRINT TO FILE YES ---
Orientation ORIENTATION --- ---
Installation of Plug&Play Printers
The installation of Plug&Play printers under Windows XP is quite simple:
After the printer is connected and switched on, Windows XP automatically recognizes it and installs its
driver, provided the driver is included in the XP installation.
If the XP printer driver is not found, Windows XP prompts you to enter the path for the corresponding
installation files. In addition to pre-installed drivers, a number of other printer drivers can be found in
directory D:\I386.
Note: When installing new printer drivers, you will be prompted to indicate the path of the new
driver. This path may be on a disk in drive A. Alternatively, the driver can be loaded via a
memory stick or USB CD-ROM drive (see section "Connection of USB Devices").
Installation of Non-Plug&Play Printers
Note: The dialogs below can be controlled either from the front panel or via the mouse and
keyboard (see sections "Connecting a Mouse" and "Connecting a Keyboard"). Mouse and
PC keyboard are absolutely essential for configuring network printers.
A new printer is installed with the INSTALL PRINTER softkey in the HCOPY menu.
COLORS
HCOPY
DEVICE
SETUP
DEVICE
1 2
! Press the HCOPY key.
The HCOPY menu will open.
To Next Page
Loading...
