Measurement Documentation R&S ESCI
1166.6004.12 4.264 E-1
Installation of Plug&Play Printers
The installation of Plug&Play printers under Windows XP is quite simple:
After the printer is connected and switched on, Windows XP automatically recognizes it and installs its
driver, provided the driver is included in the XP installation.
If the XP printer driver is not found, Windows XP prompts you to enter the path for the corresponding
installation files. In addition to pre-installed drivers, a number of other printer drivers can be found in
directory D:\I386.
Note: When installing new printer drivers, you will be prompted to indicate the path of the new
driver. This path may be on a disk in drive A. Alternatively, the driver can be loaded via a
memory stick or USB CD-ROM drive (see section "Connection of USB Devices").
Installation of Non-Plug&Play Printers
Note: The dialogs below can be operated either from the front panel or via mouse and keyboard
(see sections "Connecting a Mouse" and "Connecting a Keyboard"). Mouse and PC
keyboard are absolutely essential for configuring network printers.
A new printer is installed via the INSTALL PRINTER softkey.
! Select Add Printer in the list using the
spinwheel.
! Highlight the selected item with CURSOR
RIGHT and press ENTER or the
spinwheel to confirm the selection.
The Add Printer Wizard is displayed.
! Select NEXT with the spinwheel and press
the spinwheel for confirmation.
Local or Network Printer can be selected.
To Next Page
Loading...
