R&S ESCI Receiver – MEAS Key
1166.6004.12 4.39 E-2
Automatic Control of Line Impedance Stabilization Networks
The selected phases are controlled during the prescan and the final measurement via the USERPORT
with the LISN switched on.
Only one phase and one PE setting (1 out of n) can be selected for the prescan. Any number of settings
can be selected for the final measurement (m out of n).
All selected phase/PE combinations are measured during the final measurement and the maximum
value is determined.
FINAL MEAS menu (right side menu)
FINAL
PHASES
ESH3-Z5
ESH2-Z5
ENV 4200
OFF
PRESCAN
PHASES
PHASE L1
PHASE N
PHASE L2
PE
FLOATING
PHASE L3
PE
GROUNDED
RUN FINAL
MEAS
The LISN softkey opens the submenu for automatic control of V-
networks (LISNs)
ESH3-Z5
ESH2-Z5
ENV 4200
OFF
Softkeys ESH2-Z5/ENV 4200, ESH3-Z5 and OFF allow to select the V-network to
be controlled via the user port.
ESH2-Z5/ENV 4200 four-line V-network is controlled,
ESH3-Z5 two-line V-network is controlled,
OFF remote control is deactivated.
IEC/IEEE-bus command
:INPut:LISN[:TYPE] TWOPhase| FOURphase| OFF
To Next Page
Loading...
