The Screen R&S ESCI
1166.6004.12 3.10 E-1
In the MIXED mode, the screen is split according to fixed configurations.
Table 3-2 Assignment of windows with split screen in the MIXED receiver mode
upper (screen A) Level and frequency display
lower (screen B) Analyzer spectrum
or
upper (screen A) Analyzer spectrum
Lower (screen B) Scan spectrum
Displays that apply to only one measurement diagram appear at the edge of the diagram in question.
Displays that apply to both windows appear between the diagrams.
The SCREEN A/B hotkey is used to select the diagram for which the input of measurement parameters
or the operation of markers is valid. Measurements are performed simultaneously in both measurement
diagrams, regardless of which is currently active.
Switching from full-screen to split-screen display is done via the DISP menu.
Softkey Area
The softkeys are assigned to the nine keys on the right side of the display
The setup of the softkey area is independent of the operating mode. It consists of the following graphic
elements:
SOFTKEY
LABEL 1
Softkey menu:
indication of side menu
SOFTKEY
LABEL 2
SOFTKEY
LABEL 3
SOFTKEY
LABEL 4
SOFTKEY
LABEL 5
SOFTKEY
LABEL 6
SOFTKEY
LABEL 7
SOFTKEY
LABEL 8
SOFTKEY
LABEL 9
⇒
indication of submenu (arrow)
softkey active (green)
softkey active, opens a data
entry field (red)
softkey function not available
(without 3D frame)
Fig.3-5 Setup of the softkey area
The softkeys have different functions depending on the instrument state. Therefore, their labeling can be
varied. The labeling of all softkeys which call a submenu includes a ⇓ arrow.
The function and current state of the softkeys is indicated in the label by different texts and colors. The
color assignment is factory-set as follows:
To Next Page
Loading...
