MEAS - Analyzer R&S ESCI
1166.6004.12 4.158 E-1
Setting the Channel Configuration
MEAS - CP/ACP CONFIG submenu:
CP/ACP
CONFIG
CP/ACP
ABS REL
NO. OF
ADJ CHAN
CHANNEL
SPACING
ACP REF
SETTINGS
CHANNEL
BANDWIDTH
CHAN PWR
/ HZ
SELECT
TRACE
ACP LIMIT
CHECK
EDIT
ACP LIMIT
ADJUST
SETTINGS
NO. OF
TX CHAN
The CP/ACP CONFIG softkey opens a submenu
for configuration of the channel power and adjacent
channel power measurement independently of the
offered standards.
The channel configuration includes the number of
channels to be measured, the channel bandwidths
(CHANNEL BANDWIDTH), and the channel
spacings (CHANNEL SPACING).
Limit values can additionally be specified for the
adjacent-channel power (ACP LIMIT CHECK and
EDIT ACP LIMITS) which are checked for
compliance during the measurement.
NO. OF
ADJ CHAN
The NO. OF ADJ CHAN softkey activates the entry of the
number ±n of adjacent channels to be considered in the
adjacent-channel power measurement.
Numbers from 0 to 3 can be entered.
The following measurements are performed depending on the
number of the channels.
0 Only the channel powers are measured.
1 The channel powers and the power of the upper and lower
adjacent channel are measured.
2 The channel powers, the power of the upper and lower
adjacent channel and of the next higher and lower channel
(alternate channel 1) are measured.
3 The channel power, the power of the upper and lower
adjacent channel, the power of the next higher and lower
channel (alternate channel 1) and of the next but one
higher and lower adjacent channel (alternate channel 2)
are measured.
IEC/IEEE-bus command: POW:ACH:ACP 1
NO. OF
TX CHAN
The NO. OF TX CHAN softkey enables the entry of the number
of carrier signals to be considered in channel and adjacent-
channel power measurements.
Numbers from 1 to 12 can be entered.
The softkey is available only for multicarrier ACP
measurements.
IEC/IEEE-bus command: SENS:POW:ACH:TXCH:COUN 4
To Next Page
Loading...
