Measurement Documentation R&S ESCI
1166.6004.12 4.260 E-1
The desired format (here Portrait) is selected in the list with the spinwheel and confirmed by pressing
the spinwheel or ENTER. This closes the list and the cursor is placed again on the Orientation field.
The dialog is then closed with ESC or by clicking the Close button.
Note: The installation of new printer types is described in sections "Local Printer" and "Configuring a
Network Printer"
Selecting Alternative Printer Configurations
The analyzer is capable of managing two independent hardcopy settings. This, for instance, permits fast
switchover between printing to a file or by a printer.
DEVICE
1 2
A selection is made with the DEVICE 1 / 2 softkey which also shows settings
when the DEVICE SETUP dialog is open.
IEC/IEEE-bus command: --
Selecting Printer Colours
COLORS
The COLORS softkey gives access to the submenu where the colours for the
printout can be selected. To facilitate colour selection, the selected colour
combination is displayed when the menu is entered. The previous colours are
restored when the menu is exited.
IEC/IEEE-bus command: -
COLOR
ON OFF
The COLOR ON OFF softkey switches over from colour
output to black-and-white output. All colour-highlighted areas
are printed in white and all colour lines in black. This improves
the contrast on the printout. The default setting is COLOR ON.
IEC/IEEE-bus command: HCOP:DEV:COL ON
To Next Page
Loading...
